Table of Contents
Advertisement
12
STATus Subsystem
STATus:OPERation:CONDition?
STATus:OPERation:CONDition?
Syntax
STATus:OPERation:CONDition?
This query reads the condition register for the Standard Operation register
group and returns a decimal value which corresponds to the binary-weighted
sum of all bits set in the condition register
example, if bit 5 (decimal value = 32) and bit 9 (decimal value = 512) are set,
this command will return the decimal value "+544".
N O T E
Remarks
• A condition register continuously monitors the state of the instrument. The
• The condition register bits reflect the current condition of the instrument.
Example
& STAT:OPER:COND?
$ +32
See also
"STATus:OPERation:ENABle"
"STATus:OPERation[:EVENt]?"
296
This is a read-only register and the bits are not cleared when you read the
register. For more information on the bit definitions of the Standard
Operation register and the SCPI status diagram see the
System"
on page 12.
bits in the condition register are updated in real time and the bits are not
latched or buffered.
If a condition goes away, the corresponding bit is cleared in the condition
register.
(Table 12-1
This command reads the condition register
(bit 5 is set).
on page 297
on page 299
U3606B Programmer's Reference
on page 297). For
"SCPI Status
Advertisement
Table of Contents
