Measure Subsystem - Agilent Technologies U3606B Programmer's Reference Manual

Dc power supply

Hide thumbs Also See for U3606B:

Table of Contents

U3606B Multimeter|DC Power Supply

Programmer's Reference

MEASure Subsystem

This chapter describes the MEASure commands used to program the U3606B

over a remote interface. The MEASure? command provides the easiest way to

program the U3606B for measurements. When you execute this command, the

U3606B immediately performs the measurement. The reading is sent directly

to the U3606B output buffer.

Some measurements may result in a delayed response time in the U3606B

Multimeter|DC Power Supply. It is recommended that you increase the

SCPI query timeout to 15000 milliseconds or longer to avoid SCPI query

timeout errors.

Agilent Technologies