Table of Contents
Advertisement
FP403040 REV 2.qxp_Layout 1 25/01/2019 11:48 Page 10
IMPORTANT
DO NOT ADD BOILING WATER/VERY HOT
LIQUID TO THE JUG. ALLOW TO COOL FIRST.
Measuring Cup
•
The Measuring Cup
small quantities of liquid.
Pour the liquid through the Pouring Hole
1
in the Lid (2).
Place the Measuring Cup
2
twisting to lock/unlock. Then proceed with your
blending.
Crushing Ice
•
Follow the procedure in the 'Using your Total
Control Table Blender section, replacing food with
the ice cubes to be crushed.
•
Select Ice Crushing Button
Preset Programs.
•
Note: The maximum capacity for ice crushing at
any one time is 500ml.
Top Tips
Use your Blender for soups, sauces, drinks,
pates, mayonnaise, dressing etc.
•
Do not put dry ingredients into the Blender
without addition of other wet ingredients or liquid.
•
When blending, pour the liquids in first and then
add the solid food. Begin blending at the lower
speed and increase when needed.
10
(1)
can be used to measure
(3)
(1)
back in the Lid (2),
(13)
on the
IMPORTANT: To ensure the long life of your
blender when using the Manual Speed Settings
never run it for longer than 60 seconds and allow
to cool for 5 minutes. Switch off as soon as you
have reached the desired consistency.
•
The machine will not work if the Plastic Jug
is fitted incorrectly.
•
Don't use the Plastic Jug as a storage container.
Keep it empty when not in use.
•
Never blend more than 1 litre (1
of frothy liquids, such as milk shakes.
•
If using a max of 1.5L do not use any higher than
speed 2.
•
When blending soup do not fill over the
1 Litre mark.
•
Do not overfill the blender. This could cause
damage to the motor. The plug fuse will blow if
the blender is overloaded. Replace the fuse and
do not exceed the maximum recommended
volumes. Refer to the 'Operating chart'
on page 11.
Care And Cleaning
•
Before cleaning and maintenance, switch the
appliance off and unplug it, remove the
Plastic Jug
(5)
from the Base Unit (7).
•
After use, fill the Plastic Jug
of warm water and run for 30 seconds on the
pulse setting and repeat as necessary. Never use
abrasives or cream cleaners.
•
Clean the Base Unit
(7)
with a damp cloth or
kitchen paper roll.
•
There is a facility to wrap your power cable
around the base of the product and fit the plug
into the Plug Storage (15).
•
Reassemble the Total Control Table Blender by
carefully placing the Plastic Jug
Unit (7), ensuring it fits correctly.
•
WARNING : Never immerse the Base Unit in
water.
•
WARNING: If any liquid is spilt in the top of the
Base Unit, switch off and unplug from the
socket and dry with a cloth.
(5)
3
⁄
pints) -
4
(5)
with 1L (1
3
⁄
pints)
4
(5)
on the Base
Advertisement
Table of Contents
