MSI EFINITY Series Manual page 48

M S-7395 M ainboard
M odule Version
This item shows the version of the current USB module. (read only)
USB Devices
This item shows the number of the USB device according type of device. Ex :
show "2 Drives,1 mouse" when you insert 2 USB flash disk and a mouse.
Legacy USB Support
Select [Enabled] if you need to use a USB-interfaced device in the operating
system.
Hotplug USB FDD
Set to [Enabled] if your need to hotplug USB floppy disks.
Device Reset timeout
This item allows you set the reset timeout value. W hen the device delay over
time, the system can not detect the device.
SuperIO Configuration
Press <Enter> to enter the sub-menu.
Super IO Chip
This item shows the super IO chip's name. (read only)
Floppy Disk Controller Configuration
Press <Enter> to enter the sub-menu.
Floppy Disk Controller
This item is used to enable/disable the floppy disk controller.
Device Settings
This item shows the current setting. (read only)
Serial Port 0 / 1 Configuration
Press <Enter> to enter the sub-menu.
Serial Port
This item is used to enable/disable the serial port.
Device Settings
This item shows the current setting. (read only)
Change Settings
Select an address and corresponding interrupt for the serial port.
Serial Port Speed
This setting controls the receiving and transmitting speed of the serial port
in use.
3-14