Download Print this page

Parts List - Steelcraft 60-11380 Installation Instructions Manual

Elevation front bumper 2017 ford super duty f250-350

Advertisement

PARTS LIST:

1
Elevation Front Bumper Assembly
1
Driver/left Frame Bracket
1
Passenger/right Frame Bracket
2
Plastic Plugs for license plate mount
1
Driver/left Upper U-Bracket (OEM fog light)
1
Passenger/right Upper U-Bracket (OEM fog light)
2
Lower U-Brackets (OEM fog light only)
8
12mm x 50mm Bolt Plates
14
12-1.75mm x 50mm Hex Bolts
Passenger/right
Upper U-Bracket
OE fog light only
Passenger/right Frame Bracket
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. BUMPER IS HEAVY, ASSISTANCE IS
HIGHLY RECOMMENDED TO AVOID POSSIBLE INJURY OR DAMAGE TO THE VEHICLE.
1. Remove the license plate and bracket. On models with factory fog lights, unplug both lights.
Release the wiring harness from the clips attached to the back of the bumper, (Figures 1 & 2).
Move harness away from bumper.
2. Next, remove the plastic lower air dam from the bottom of the bumper, (Figure 3). Remove the
outer bumper supports attaching the outer ends of the bumper to the sides of the frame,
(Figure 4). Remove the plastic covers from the tow hooks to uncover the bumper bolts,
(Figure 5).
3. Place blocks or jack stands under the front bumper to support it during mounting bolt removal.
Once the bumper has been safely supported, remove the (8) factory bumper bolts, (Figure 6).
WARNING! Assistance is required to hold the bumper in place during bolt removal to prevent
the bumper from falling. Carefully slide the bumper off over the tow hooks.
4. Remove the tow hooks from the ends of the frame, (Figure 7). Next, remove the factory hex
nuts, lower frame extension and double bolt plates from the ends of the frame, (Figures 2 &
7).
(2) License Plate Plugs
(4) 12mm Bolt Plates
Driver/left Frame Bracket
2017 FORD SUPER DUTY F250-350
36
12mm x 32mm x 3mm Flat Washers
22
12mm Lock Washers
22
12-1.75mm Hex Nuts
2
8-1.25mm x 20mm Hex Bolts
4
8mm x 24mm x 2mm Flat Washers
2
8mm Nylon Lock Nuts
4
6mm x 16mm Hex Bolts
4
6mm x 18mm x 1.6mm Flat Washers
4
6mm Lock Washers
Page 1 of 6
ELEVATION FRONT BUMPER
Driver/Left Upper
U-Bracket OE fog
light only
10/2716 (DP)

Advertisement

loading