FORTIS REAR BUMPER 2014-19 TUNDRA PARTS LIST: 12mm x 37mm x 3mm Flat Washers Fortis Rear Bumper 12mm Nylon Lock Nuts Driver/Left Frame Bracket 8mm x 25mm Hex Bolts Passenger/Right Frame Bracket 8mm x 16mm x 1.6mm Driver/Left Support Bracket...
Page 3
FORTIS REAR BUMPER 2014-19 TUNDRA c. Next, select the Driver/Left Mounting Bracket. Attach the bracket to the outside of the frame and support bracket with (4) 14mm Hex Bolts, (8) 14mm Flat Washers, (4) 14mm Lock Washers, and (4) 14mm Hex Nuts (Figure 9—11). Do not tighten hardware at this time.
Page 4
FORTIS REAR BUMPER 2014-19 TUNDRA (Fig 1) Unplug and remove 7-wire trailer plug, unplug license plate lights and sensors if equipped Rear (Fig 2) Remove factory bolts attaching bumper assembly to frame WARNING! Do not remove bumper bolts unless the bumper is properly supported on blocks or stands or the bumper may fall.
Page 5
FORTIS REAR BUMPER 2014-19 TUNDRA Plastic Clip Factory Hardware (Fig 5) Remove Factory Hardware and Plastic Clip from the underside of the bumper (Fig 6) Remove plastic cover from the top of the bumper Note: The support brackets that come with the kit install in the same place factory support brackets would be installed.
Page 9
FORTIS REAR BUMPER 2014-19 TUNDRA Rear WARNING! Do not crawl under bumper unless the bumper is properly supported on blocks or stands or the bumper may fall. (2) 12mm Hex Bolts (4) 12mm Flat Washers (2) 12mm Lock Washers (2) 12mm Hex Nuts...