Gravely Ariens 815134 Owner's/Operator's Manual page 13

6. Mount front of support bar to the mower frame
using 3/8 x 3/4" clevis pin, 3/8" washer and bow-tie
locking cotter pin. (The bar must be on the inside of
the frame, as shown in Figure 14.) Tighten
hardware installed in step 5. See Figure 14.
3/8" Washer & Bow-Tie Locking
Cotter Pin (Not Shown)
CAUTION: MAKE SURE the heat resistant
(smooth side) side of the mesh bags is facing
the unit.
INSTALL BAG ON FRAME
1. Thread the bag frames (item 23) through the sleeve
on the open end of the mesh bag (item 2). See
Figure 15.
2. Install the 3/8 x 1/2 x 3" plastic tubes (item 24) on
the ends of the bag frames and push then ends
together. on the ends of the bag frame and push
the ends together. See Figure 15.
NOTE: The rope handle on the bottom of the bag will
point to the outside when the bag is assembled correctly.
Clevis
Pin
Figure 14
Thread bag frame (item 23) through sleeve in mesh
bag (item 2).
Install 3/8 x 1/2 x 3" plastic tube (item 24) on each end
of frame and push the ends together.
13
Figure 15