Gravely Ariens 815134 Owner's/Operator's Manual page 12

3/8 x 1" Hex Bolt &
3/8" Locking Nut
2. Insert L bracket into the receiver and fasten using
1/2 x 2 3/4" round head square neck bolt and wing
knob. Do not fully tighten. See Figure 11.
3. Install front studded wing knob into front of receiver.
Tighten studded wing knob and hardware installed
in step 2.
1/2" Studded Wing Knob
L Bracket
4. Position left hood assembly receiver over L bracket
and install onto bracket. See Figure 12.
NOTE: It may require two people to position hood
assembly onto bracket.
Receiver
Figure 10
1/2 x 2 3/4" Hex Bolt &
1/2" Wing Knob
Figure 11
L Bracket
Hood
Assembly
5. Position bagger support bar inside of engine control
cables and attach support bar to L bracket using 1/2
x 2 3/4" hex bolt, 1/2" flat washer and 1/2" flange
nut. Flat washer is positioned between bar and L
bracket. Do not fully tighten hardware. See
Figure 13.
1/2 x 2 3/4" Hex Bolt,
1/2" Flat Washer &
1/2" Flange Nut
12
Figure 12
Support Bar
Engine Control Cables
Figure 13