Dell DSS 1510 Owner's Manual page 62

2. To release the memory module from the socket, simultaneously press the ejectors on both ends of the memory module socket.
3. Lift and remove the memory module from the system.
Figure 19. Removing the memory module
a. memory module
b. memory module socket
c. memory module socket ejector (2)
Next steps
1. Install the memory module.
NOTE: If you are removing the memory module permanently, install a memory module blank.
2. If removed, install the PCIe expansion card riser.
3. If disconnected, reconnect the cables to the expansion card(s).
4. Install the cooling shroud.
5. If closed, open the expansion card latch on the cooling shroud to support the full length expansion card.
6. Follow the procedure listed in the After working inside your system section.
Related tasks
Before working inside your system
Removing the cooling shroud
Removing the expansion card riser
Installing memory modules
Installing the expansion card riser
Installing the cooling shroud
After working inside your system
Related reference
Safety instructions
62 Installing and removing system components