Initial System Setup And Configuration; Setting Up Your System; Options To Set Up Bmc Ip Address; Log In To Bmc - Dell DSS 1510 Owner's Manual

Initial system setup and configuration

Setting up your system

Complete the following steps to set up your system:
Steps
1. Unpack the system.
2. Install the system into the rack. For more information about installing the system into the rack, see your system Rack Installation
Placemat at Dell.com/dssmanuals.
3. Connect the peripherals to the system.
4. Connect the system to its electrical outlet.
5. Turn the system on by pressing the power button.
6. Turn on the attached peripherals.

Options to set up BMC IP address

You must configure the initial network settings based on your network infrastructure to enable the communication to and from BMC. You
can set up the IP address by using one of the following interfaces:
Interfaces Document/Section
iDRAC Settings See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals
utility
Dell Deployment See Dell Deployment Toolkit User's Guide at Dell.com/openmanagemanuals
Toolkit
Remote Access See RACADM Command Line Interface Reference Guide and Integrated Dell Remote Access Controller User's
Controller Admin Guide at Dell.com/idracmanuals
(RACADM)
Remote Services See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals
that include Web
Services
Management
(WS-Man)
You must use the default BMC IP address 192.168.0.120 to configure the initial network settings, including setting up DHCP or a static IP
for BMC.
NOTE: To access BMC, ensure that you install the remote management port card or connect the network cable to the
Ethernet connector 1 on the system board.
NOTE: Ensure that you change the default user name and password after setting up the BMC IP address.

Log in to BMC

You can log in to BMC as:
• BMC local user
• Microsoft Active Directory user
• Lightweight Directory Access Protocol (LDAP) user
The default user name and password are root and calvin. You can also log in by using Single Sign-On or Smart Card.
24 Initial system setup and configuration
4