Troubleshooting Modem Installation - IBM 10/100 EtherJet CardBus Adapter with 56K Modem Installation And User Manual

fcr0mst.book Page 3 Monday, July 13, 1998 9:36 AM
Parameter
DirectEnable
EarlyTransmit
InterruptStyle
LineSpeed
LineMode
Network
Address
Socket
For network administrators only: The network node address
can be modified by specifying a value for the Network Address
such as 0080C7112233. If the user does NOT specify a Network
Address, then the IBMC.SYS driver uses the network node
address contained in the EtherJet CardBus Adapter with 56K
Modem Card Information Structure.
Note: For definitions of the keywords above, see the Keyword
Reference (All Drivers) in Chapter 4, "Diagnostics and
Troubleshooting".

Troubleshooting Modem Installation

Review this section if any of the following problems occur:
• Modem initialization errors occur when attempting to dial-out
using a communications application.
• Connection failures or other problems occur.
Valid Values Reg. Value
OFF
ON
AutoDetect
OFF
ON
AutoDetect
PCI-IRQ
ISA-IRQ
AutoDetect
10 Mbps
100 Mbps
AutoDetect
Half-Duplex
Full-Duplex
See Network Administrators, note
below.
Autodetect 0
1, 2, 3, 4 1, 2, 3, 4
Windows 95 and Windows 98 Installation
1
2
0
0
1
0
1
2
0
1
2
0
1
2
2-3