Table of Contents
Advertisement
While running the MAKEMS.BAT batch file, you might see an error message
indicating that a >CAT file could not be copied. Ignore this message.
Windows NT Version 4.0
After you have put the adapter in the computer, connected the cables, and started
Windows NT, install the correct drivers by performing the following steps.
1. Double-click Network in the Control Panel.
2. Click Adapters.
3. Click Add. You will see a list of adapters.
4. Do not select an adapter from this list. Instead, insert the IBM Installation and
5. Specify the appropriate drive in the dialog box and click OK. Then follow the
6. Click Close to finish.
7. Restart Windows NT when prompted.
Windows NT Version 3.51
After you have put the adapter in the computer, connected the cables, and started
Windows NT, install the correct drivers.
1. Double-click Network in the Control Panel.
2. Click Add Adapter.
3. When the list of adapters appears, scroll to the end of the list and select
4. Insert the IBM Installation and Drivers CD-ROM or diskette in the appropriate
5. Select Netfinity 10/100 Ethernet Adapter and click OK. Drivers and utilities are
6. The TCP/IP Configuration dialog box appears. Enter the appropriate information
7. When prompted, restart Windows NT.
Windows NT Troubleshooting
If Windows NT reports an error or you cannot connect to the network, try the
suggestions here first, then see "Appendix F. Troubleshooting and Testing the
Adapter" on page 31 if necessary.
v Make sure that you use the drivers for this adapter. Drivers are located on the
v Make sure that the driver is loaded and that the protocols are bound. Check the
v Check the Windows NT Event Viewer for error messages.
v If you are attaching to a NetWare network, check your frame type and verify that
v Test the adapter with the IBMSet advanced configuration utility that was installed
Drivers CD-ROM or diskette into the appropriate drive and click Have Disk.
prompts to complete installation. When the adapter is added you will see a new
adapter listed in the Network adapter list.
<Other> Requires disk from manufacturer and then click Continue.
drive, specify that drive, and click OK.
then installed.
and click OK. Remove the installation disk.
Note: For troubleshooting information, see "Windows NT Troubleshooting".
IBM Installation and Drivers CD-ROM or diskette.
settings in the Control Panel Network/Bindings dialog box.
NetWare client or server software has been installed.
on your system when you installed the Netfinity 10/100 Ethernet Adapter. To start
Chapter 2. Configuring Your Adapter
11
Advertisement
Table of Contents
Troubleshooting
