Throttle Cable - Suzuki LT-Z90K7 Setup Manual

The line drawings on page 26, 27 and 28 show
the proper routing of the control cables and
wiring. Refer to drawings in addition to follow-
ing the instructions carefully.
A: Front brake cable
B: Throttle cable
C: Left switch wiring harness
D: Parking brake switch lead wire
E: Rear brake cable

THROTTLE CABLE

Remove the screw to take off the throttle case cover.
Insert the inner cable end into the recess of throttle
cable lever correctly.
A: Throttle case cover
B: Screw
C: Cable end
D: Throttle cable lever
Pull on the outer cable and insert the outer cable cap
to the recess of throttle case correctly as shown.
NOTE:
Before installing the cable, grease the cable
end.
A: Throttle cable
B: Outer cable cap
C: Throttle case
D: Recessed area
Check the gasket at the correct position.
Reinstall the throttle case cover.
Check to ensure that the throttle operates
freely and closes automatically.
A: Gasket
6