Rear Brake Cable - Suzuki LT-Z90K7 Setup Manual

REAR BRAKE CABLE

Turn the brake cable adjuster and lock nut in as far as
possible and align the slots.
Insert the inner cable end into the recess of brake
lever, then pull on the outer cable housing and insert it
into the adjuster.
NOTE:
Before installing the cable, grease the cable
end.
A: Brake cable
B: Adjuster
C: Lock nut
D: Cable end
Set the pin into the brake cam lever.
Insert the end of the brake cable into the pin hole.
Attach the adjuster nut on the end of the brake cable.
Do not adjust at this time.
Adjustment will be covered in the SERVICING section.
A: Brake cam lever
B: Pin
C: Adjuster nut
7