Turning Off The Main Power; Saving Energy - Ricoh Martini-C3.5 Operating Instructions Manual

Getting Started

Turning Off the Main Power

Turn off the main power as follows:
1
Important
❒ Do not turn off the main power switch when the On indicator is lit or blink-
ing. Failure to observe this may result in damage to the hard disk or memory,
leading to malfunction.
❒ Be sure to pull out the power cord only after you have turned off the main pow-
er switch. Not doing this may result in damage to the hard disk or memory.
A
Make sure the On indicator is not lit.
B
Open the switch cover, and turn off the main power switch.
The main power indicator goes off.
Note
❒ The On indicator does not go off, but blinks in direct dialing mode even if
you press the Operation switch. When this happens, check the items be-
low, and turn off the main power switch.
• the computer is not controlling the machine.

Saving Energy

This machine has the following two energy saving functions.
❖ Energy Saver
If you do not use the machine for a certain period after an operation, or when
you press the {Energy Saver} key, the display disappears and the machine
goes into Energy Saver mode. When you press the {Energy Saver} key again,
the machine returns to the ready condition. The machine uses less electricity
in Energy Saver mode.
You can change the amount of time the machine waits before switching to En-
ergy Saver mode after copying has finished or the last operation is performed.
See "Timer Settings", General Settings Guide.
❖ Auto Off
The machine automatically turns itself off when the job is finished, after a cer-
tain period of time has elapsed without any operation. This function is called
"Auto Off".
You can change the Auto Off time. See "Timer Settings", General Settings
Guide.
32