Replacement Routines; Preparation; Floorstand Model; Opening The Server - Fujitsu PRIMERGY TX150 S6 Service Supplement Manual

4

Replacement routines

V
CAUTION!
Observe the safety instructions in the
et seq. .
4.1

Preparation

4.1.1

Floorstand model

I
You will find a detailed description of "Opening the server" and
"Removing the front cover" in the Options Guide TX150 S6.
4.1.1.1

Opening the server

Ê Terminate all applications and shut down the server correctly.
Ê If your operating system has not switched off the server, press the on/off
switch for at least four seconds ("Power override" function).
Ê Pull all power connectors out of the power outlets.
Ê If required, remove the lock on the side cover.
Ê Unlock the server.
Ê Loosen the two knurled screws at the server's rear side.
Ê Push back the left-hand side cover approxiate 2 cm.
Ê Remove the left-hand side cover.
4.1.1.2

Removing the front cover

Remove the front cover when making the following replacements:
– Replacing the operating panel
– Replacing the DVD/DVD-RW drive
– Replacing the intrusion switches
Ê Push the drive cover up as far as possible.
Ê Remove the hard disk cover.
TX150 S6
chapter "Safety notes" on page 11
Service Supplement 17