Replace Headlight; Clearing Blockage - Oreck Quest Pro Canister FC1000 User Manual

Maintenance
- continued
How to Replace the Brushroll
DISCONNECT VACUUM FROM ELECTRICAL OUTLET!
1. Remove hood, brushroll cover, belt and brushroll. See
Steps 1-6.
2. Discard the old brushroll.
3. Install the new brushroll and belt. See Steps 7-9.
How to Replacing the Headlight
• The headlight is located inside of the power nozzle.
The light is on whenever the vacuum is turned on.
1. Disconnect power nozzle from the extension wand.
2. Remove the hood. See Steps 1-2.
3. Pull the old bulb from the socket to remove. Push the
new bulb into socket.
4. Replace the hood. See Steps 9 & 1.
ALWAYS DISCONNECT
VACUUM FROM
ELECTRICAL OUTLET
BEFORE STARTING
THIS PROCEDURE!
How to Clear Blockages
• Low suction or pick up may be due to a blockage
in the system. Refer to the following steps to check
for blockages, continuing with each step until the
blockage is found.
Hose/Wand Blockage
• Disconnect power nozzle and wand from handle.
• Plug vacuum in and turn it on. Check the hose end for
suction. Remove any obstructions.
19