Oreck Quest Pro Canister FC1000 User Manual page 20

Maintenance
- continued
Check/Remove Belt
• If belt is not broken but is stretched or cut, pull it off
the motor pulley (D).
Remove/Replace Belt
• Lift up the end of the brushroll. Remove the old
belt from the brushroll pulley (E) and replace with
a new belt. The lettering on the belt must be visible.
(Lettering should be facing out.)
• Stretch the belt and attach to the motor pulley.
Replace Brushroll
• Hold the opposite end of brushroll in place. Push the
belt end forward and down while rotating the end
plate (F) until it slides into place. Turn the brushroll,
making sure it rotates freely.
17
Step 5
Step 6
Step 7