Oreck Quest Pro Canister FC1000 User Manual page 23

Maintenance
- continued
• If there is no blockage in the hose. Remove the power
nozzle from wand and attach wand to hose. Check for
suction and remove any blockages.
Nozzle Blockage
• If the nozzle becomes clogged, use the following
procedures to check for and clear the blockage.
• If blockage is severe enough the nozzle will shut
off. After the blockage is cleared you must push the
Overload Protection Reset button (A) before the
nozzle will operate again.
• Make sure power nozzle is disconnected from wand.
Then check for blockage in nozzle connection (B).
• There is an additional panel on the bottom of the
nozzle (C). This opening provides a secondary place
to check and clear blockage.
20