Siemens SIMATIC NET SCALANCE M826 Operating Instructions Manual page 26

Description of the device
2.5 SET button
You will find more information in the section "Service and Maintenance" in the
SCALANCE M-800 Web Based Management configuration manual.
● Reset to factory defaults
– Hold down the button until the red fault LED (F) stops flashing after approximately 10
– Now release the button and wait until the fault LED (F) goes off again. The device then
You will find more information in the SCALANCE M-800 Web Based Management
configuration manual.
EXPLOSION HAZARD
Do not press the SET button if there is a potentially explosive atmosphere.
26
seconds and is permanently lit.
starts automatically with the factory settings. By resetting to the factory configuration
settings, the device loses its configured IP address. Since the device does not have a
configured IP address, you need to assign an IP address e.g. via a DHCP server or
using the Primary Setup Tool
WARNING
Operating Instructions, 08/2018, C79000-G8976-C362-05
SCALANCE M826