Cisco WS-X3011 Configuration Note page 23

Configuring the Synchronous Serial Interfaces
The synchronous serial interfaces are configured to allow connection to WANs. After the Ethernet
port has been configured, configure the synchronous serial interfaces as follows:
Press Return or enter yes to configure serial port 0:
Step 1
Configuring interface Serial0:
Is this interface in use? [yes]:
Determine which protocols you want on the synchronous serial interface and enter the
Step 2
appropriate responses. In the following example, the system is configured for IP,
AppleTalk, and IPX:
Configure IP on this interface? [yes]:
Configure IP unnumbered on this interface? [no]:
IP address for this interface: 172.16.73.1
Number of bits in subnet field [8]:
Class B network is 172.16.0.0, 8 subnet bits; mask is
255.255.255.0
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [yes]:
AppleTalk starting cable range [2]: 4
AppleTalk ending cable range [3]: 4
AppleTalk zone name [myzone]: ZZ Serial
AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
IPX network number [2]: B002
Configure the second synchronous serial interface, for example, as follows:
Step 3
Configuring interface Serial1:
Is this interface in use? [yes]:
Configure IP on this interface? [yes]:
Configure IP unnumbered on this interface? [no]:
IP address for this interface: 172.16.74.2
Number of bits in subnet field [8]:
Class B network is 172.16.0.0, 8 subnet bits; mask is
255.255.255.0
Configure AppleTalk on this interface? [no]: yes
AppleTalk starting cable range [3]: 5
AppleTalk ending cable range [4]: 5
AppleTalk zone name [myzone]: ZZ Serial
AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
IPX network number [3]: B003
The configuration you entered is now displayed and you are asked if you want to use the
Step 4
displayed configuration. If you enter no, you will lose the configuration information you
just entered and you can begin the configuration again. If you enter yes, the configuration
will be entered and saved in the startup configuration:
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
Proceed to the section "Cisco IOS Software Basics" for more information about the Cisco IOS
software.
Configuring the Router Card for the First Time
Router Card (WS-X3011) Configuration Note 23