Cisco WS-X3011 Configuration Note page 13

Figure 8
Encountering Communication Problems
To adjust the baud rates between the console and the switch if the diagnostic list does not appear or
the list is garbled, use the Autobaud routine within the switch. Press the Reset button on the switch
and wait for the internal diagnosis to finish (the Diagnostic LED goes off). Resetting the switch
resets the Autobaud routine to its default mode of enabled.
Note
configuration. Pressing the Reset button will cause the switch to disconnect from the Stack and
might cause Stack configuration information to change.
The console command keys that initiate the Autobaud routine depend on the type of console. Four
of the command keys are RETURN, the combination keys ALT-B, the BREAK key, or ESCAPE.
After the DIAG LED goes out, at the console press one of the command keys repeatedly. If there is
no response, wait several seconds and again press it repeatedly. If there is still no response, perform
the same routine using the other command keys.
If none of the command keys work but there is garbled output on the screen, push the SysReq button
on the switch. As soon as garbled characters appear, press the console's RETURN key twice in rapid
succession. (Again, try the other command keys as necessary.)
You can toggle back and forth between the two console interfaces by pressing
Note
Ctrl-R.
Greeting Screen
Cisco Catalyst Manager
(c) Copyright Cisco Systems Inc., 1996-All rights reserved
MAC Address: 00 80 24 1D D9 E0
System Contact:
Type Password, then press <RETURN>:
-- No password has been set, press <RETURN> to continue --
Do not press the Reset button on the switch if it is connected to other switches in a Stack
Encountering Communication Problems
Router Card (WS-X3011) Configuration Note 13