Cisco WS-X3011 Configuration Note page 16

Configuring the Router Card
Figure 10
Straight-through
RJ-45-to-RJ-45 cable
Configuring the Router Card
This section describes how to configure the router card and contains the following topics:
•
•
•
•
•
•
This section provides minimum software configuration information. Detailed software configuration
information is available in the Cisco IOS configuration guide and command reference publications.
These publications are available in the CD ROM package or you can order printed copies. Refer to
the section "Ordering Documentation" at the end of this document.
Access the Router Card Command-Line Interface
To access the router card commad-line interface (CLI), perform the following steps:
Step 1
16 Router Card (WS-X3011) Configuration Note
Connecting an NT1 Device
BRI 0
ETH 0 SERIAL 0
SERIAL 0
SERIAL 1
FLEX SLOT DIAG
BRI 0
SUPERV ISIOR ENGINE
ISDN BRI port (RJ-45)
S/T interface
Booting the Switch with the Router Card for the First Time
Configuring the Router Card for the First Time
Cisco IOS Software Basics
Configuring ISDN
Verifying Network Connectivity
Getting More Information
Connect a console terminal to the console port on your switch. (For more information,
refer to the "Connecting the Console" section in this document.)
SERIAL 1
AUX
WS-X3011
NT1 device
U interface
Switch