System Installation; Table 1-2 Gtx 335 Pre-Installation Checklist; Pre-Installation Checklist - Garmin GTX 335 w GPS Installation Guidance

1.5 System Installation

This section gives equipment information to install the GTX system and related hardware. For interconnect
diagrams, refer to section B.
1.5.1

Pre-Installation Checklist

Before beginning a GTX system installation the installer must make sure the aircraft meets the prerequisites
for the installation of the GTX system under this STC. Use the checklists from table 1-2 to determine the
necessary requirements that must be met before the installation of the GTX is started in a specific aircraft.
Make sure each of the items are completed as necessary before modifying.
Prerequisite
Aircraft is on AML
Approved uncorrected pressure altitude
source or GAE option installed
Satisfactory SBAS/GPS antenna installed
Satisfactory transponder antenna installed Section 3.11
Satisfactory attachment provisions have
been identified
Satisfactory electrical bonding provisions
have been identified
Planned equipment interfaces are
approved under the STC or have other
FAA approval
Installation/operational limitations
reviewed to make sure no adverse impact
to installation
Aircraft electrical system is sufficient for
the installation
Aircraft does not have a TCAS II system
190-00734-17
Rev. 1

Table 1-2 GTX 335 Pre-Installation Checklist

Reference
AML
Appendix C
Appendix C
Section 3.15
Appendix C
Section 2
Section 3.16
Section 2
GTX 335
with GPS
GTX 335 w/GPS Installation Guidance
Complete
Page 1-11