Figure B-5 Gtx 335 - Altitude Data Source Interconnect - Garmin GTX 335 w GPS Installation Guidance

NOTES
1
USE 1N4007 DIODE FOR ENCODER POWER
2
TO GTX #2 IF INSTALLED. RS-232 SPLICE MUST BE MADE ADJACENT TO GTX #1 CONNECTOR AS SHOWN.
CONFIGURE ENCODER OUTPUT TO "TRIMBLE/GARMIN 9600 BPS" FORMAT IF USING RS-232 SOFTWARE
3
METHOD.
PN 2 CAN BE LEFT OPEN IF 100' RESOLUTION IS DESIRED (DEFAULT).LIMIT STRAP LENGTH TO SPECIFIED
4
LENGTH IN THE MANUFACTURERS INSTALLATION MANUAL.
5
POWERING SAE 5-35 THROUGH THE SWITCHED OUTPUT IS OPTIONAL
6
RS-232 PORTS 1 THROUGH 3 ARE AVAILABLE.
7
FOR THE SHADIN, ONLY 1 INPUT IS NECESSARY (I.E., RS-232 OR ARINC 429, BUT NOT BOTH).
8
ARINC IN 2 CAN BE USED INSTEAD OF ARINC IN 1.

Figure B-5 GTX 335 - Altitude Data Source Interconnect

190-00734-17
Rev. 1
Sheet 2 of 2
GTX 335 w/GPS Installation Guidance
Page B-9