Table of Contents
Advertisement
Reinstall TV
Starts a TV initialization to reset all settings to
default and replace (reinstall) all channels.
1 Press [Home/Menu] ] > [TV Setup>
[OK].
2 Select [Setup] > [TV settings] >
[Reinstall TV], then press OK.
TV will perform a power down cycle going into
standby and then starts-up again. If the TV
stays in Standby mode, wake TV up with
switch on button on remote control.
1 Region OSD is displayed:
Region
Australia
Europe
Select [Europe] and press <OK>.
2 Select language OSD is displayed:
Select [xxxx]
(i.e. language from list)
<OK>.
3 Select install country OSD is displayed:
Select [xxxx]
(i.e. country from list)
<OK>.
4 Select TV placement OSD is displayed:
[Wall mounted]:
mounting
[On a TV stand]:
and press <OK>.
5 Select TV location OSD is displayed:
[Home]:
Always select this
[Shop]:
Shop mode, not to be used
and press <OK>.
6 Universal access for the visual and
hearing impaired OSD is displayed:
[No]:
No special settings
[Yes]:
Special settings configured
and press <OK>.
PrimeSuite xxHFL4373D/10
and press
and press
in case of wall
in case of stand
7 Press [Settings] to continue and install
channels.
Perform the following steps:
[
Install TV channels] and press <OK>
[Continue]
[Settings]
A screen is displayed to make changes to set
the channel list/map configuration:
[Symbol rate mode]:
[Symbol rate 1]:
[Symbol rate 2]:
[Frequency scan]:
[Frequency step]:
[Network Frequency Mode]:
[Network Frequency]: 000.00 (to set)
[Analogue channels]: On
[LCN Sorting]:
[Reset]:
[Done]:
Automatic
TV will use the preset
Symbol rate (6.900/6.875)
Manual
Option to set Symbol rate 1
and Symbol rate 2
0.000 (to set)
0.000 (to set)
Quick scan
Install channels based on a
pre-configured data table
Full scan
Install channels based on
scanning the whole
frequency spectrum
1 MHz
With Full scan, step size to
search for channels is 1 MHz
8 MHz
With Full scan, step size to
search for channels is 8 MHz
Automatic
TV will set the Network
frequency based on a pre-
configured data table
Manual
Option to set Network
frequency
TV will scan also analogue
channels
Off
TV will not scan analogue
channels
On
TV will scan also analogue
channels
Off
TV will not scan analogue
channels
On
Once finished select
[Done] and press <OK>
Page 29
Hide quick links:
Advertisement
Table of Contents
