Suzuki Wagon R Instruction Manual page 198

000.book 7 page Friday, July 28, 2017 2:30 PM
If the select lever is in other than P,
you can not return to LOCK (OFF).
 The engine switch may not return
to LOCK (OFF) due to breakdown of
the select lever.
→ page 4-13 (When returning the
engine switch)
■ When the push indicator flashes and
the power does not switch
It is probable that the mobile remote
control is not detected in "Operating
range inside the car" (see page 4-5). The
driver wears a mobile remote control and
please retry the operation. If it still does
not switch, there is a danger of battery
exhaustion on the mobile remote control.
Follow the procedure below to switch.
Press the engine switch (1) without
1
stepping on the brake pedal.
Push indicator light in the meter
(Lock switch side) of the portable
2
remote control (2) to the engine
switch for about 2 seconds within
about 10 seconds that is blinking.
Push indicator light
While blinking, the immobilizer
warning light will light for about
5 seconds.
When driving / engine start / stop
Advice
(2)
※If it does not switch even after
performing the above procedure,
there may be another cause such as
lead battery rise. Please contact
Suzuki store or Suzuki agent.
Advice
 If you change the setting (customize),
you can ring the warning buzzer (indoor
buzzer) outside the detection range of the
remote controller one time. For setting
change, consult a Suzuki store or Suzuki
agent.
 When the cellular remote control's
battery exhaust is near, D
Turn on the engine switch
, The portable remote control battery warning
light in the meter will be displayed for about 15 seconds.
→ page 3-9
(Mobile Remote Control Battery
Consumption Warning Light)
→ page 6-10
(Remote control key battery exchange)
(1)
63R40050
4
When
4-7