Operating Instructions; Unpacking; Assembly - 3M Versaflo M Series User Instructions

When assembled according to these User Instructions, 3M™ Headgear Assemblies Series M-100,
M-200, M-300, and M-400 meet the requirements of the ANSI Z87.1-2010 standard for eye and face
protection devices. In addition, M-300 and M-400 Series Headgear Assemblies meet the requirements of
the ANSI Z89.1-2009 (Type I, Class G) standard for industrial head protection.
Occupational use of these products for eye and face and/or head protection must be in compliance
with applicable health and safety standards. In the US, employers must comply with the OSHA personal
protective equipment (PPE) standard (29 CFR 1910.132) and, as applicable, the eye and face standard
(29 CFR 1910.133) and the head protection standard (29 CFR 1910.135). In Canada consult the
applicable standard(s) for your jurisdiction.

OPERATING INSTRUCTIONS

Unpacking

Inspect the package contents for shipping damage and ensure all components are present. The
product should be inspected before each use following the procedures in the "Inspection" section of
these User Instructions.

Assembly

M-Series Headgear
M-Series M-105, M-107, M-206, M-207, M-305, M-307, M-405, and M-407 are provided fully
assembled. Prior to use, ensure any protective covering or film that may have been placed over the visor
to protect it during manufacturing or shipping is removed. When using the M-101, M-301, or M-401
install a visor and faceseal (M-101/301) or inner and outer shroud (M-401) prior to use following the
procedures in the "Replacement Parts and Accessories" section of these User Instructions.
Connecting & Disconnecting Breathing Tubes
- Connect approved breathing tubes by pushing the QRS (Quick Release Swivel) end of the breathing
tube (i.e. end with the blue pinch clip) onto the air inlet of the headgear (Fig. 1a). The breathing tube
should make an audible click when attached. Verify breathing tube is secured to the headgear by
pulling on the connection. If it is not securely connected, detach and reconnect.
- To disconnect the breathing tube, compress the tabs on the end of the QRS to release and pull back
to remove (Fig. 1b).
PAPR/SA Components
Read completely and follow the assembly instructions in the User Instructions provided with your 3M™
PAPR or Supplied Air Unit.
sales@bestmaterials.com
Distributed by Best Materials® LLC
Fig. 1a
5
| http://www.bestmaterials.com
Fig. 1b
| 1-800-474-7570