Limitations Of Use; Respirator Program Management; Niosh - Approval, Cautions, & Limitations; Additional Certifications - 3M Versaflo M Series User Instructions

Limitations of Use

1. Do not wear this respirator to enter areas where:
a. Atmospheres are oxygen deficient.
b. Contaminant concentrations are unknown.
c. Contaminant concentrations are Immediately Dangerous to Life or Health (IDLH).
d. Contaminant concentrations exceed the maximum use concentration (MUC) as determined using
the Assigned Protection Factor (APF) for the specific respirator system or the APF mandated by
specific government standards, whichever is lower. See "APF" section of these User Instructions.

Respirator Program Management

Occupational use of respirators must be in compliance with applicable health and safety standards. By
law, US employers must establish a written respiratory protection program meeting the requirements of
the OSHA Respiratory Protection Standard 29 CFR 1910.134 and any applicable OSHA substance specific
standards. For additional information on this standard contact OSHA at www.OSHA.gov. In Canada, CSA
standard Z94.4 requirements must be met and/or requirements of the applicable jurisdiction, as appropriate.
The major sections of 1910.134 are listed here for reference. Consult an industrial hygienist or call 3M
Technical Service with questions concerning applicability of these products to your job requirements.
Major Sections of OSHA 29 CFR 1910.134
Section
A Permissible Practice
B Definitions
C Respiratory Protection Program
D Selection of Respirators
E Medical Evaluation
F Fit Testing
G Use of Respirators
H Maintenance and Care of Respirators
I Breathing Air Quality and Use
J Identification of Cartridges, Filters, and Canisters
K Training and Information
L Program Evaluation
M Recordkeeping
NIOSH - Approval, Cautions, & Limitations
These products are one component of a NIOSH approved respiratory protection system. Refer to the User
Instructions and/or the NIOSH Approval Label provided with the 3M™ Supplied Air (SA) or Powered Air
Purifying (PAPR) Blower Unit for approved configurations and applicable NIOSH Cautions and Limitations.

Additional Certifications

1. These products meet the requirements of certain industrial eyewear standards and with some
models, certain industrial head protection standards. They do not provide complete head, eye,
and face protection from severe impact and penetration and are not a substitute for good safety
practices and engineering controls. Misuse may result in serious injury or death. For proper
use, see supervisor, refer to the product User Instructions or contact 3M Technical Service.
2. When exposed to eye and face hazards, wear additional eye and/or face protectors appropriate to
the hazard. ANSI Z87.1-2010, incorporated by reference in the OSHA Eye and Face Standard 29
CFR 1910.133, suggests safety spectacles or goggles should be worn in conjunction with loose
fitting respirators if the visor can be raised from the normal position during use. Failure to do so
may result in serious injury.
sales@bestmaterials.com
Distributed by Best Materials® LLC
Description
W WARNING
4
| http://www.bestmaterials.com | 1-800-474-7570