Singer cpennveiDUCH fashion machine 1036 Manual page 9

Changing One-Piece Presser Foot
Instrukcje obsługi maszyn do szycia firm Polskich jak i zagranicznych np. Singer Toyota Pfaff Gritzner Łucznik Arka
CHANGING PRESSER FEET
Snap-on Presser Feet
Most of the presser feet furnished with your
machine snap on and off a common shank.
1. Raise take-up lever to its highest position
by turning the hand wheel toward you.
2. Raise presser foot.
3. Press toe of presser foot upward (as far as
it will go) and then snap down to remove.
4. Center the new presser foot under the
shank and lower the presser-foot lifter so
that the shank fits over the presser-foot
pin.
5. Press presser-foot screw down until foot
snaps into place.
To remove and replace the shank of snap-on
presser feet, follow instructions below for
one-piece presser feet.
One-Piece Presser Feet
1. Raise needle to its highest position and
raise the presser foot.
2. Loosen presser foot screw and remove the
foot guiding it to the right.
3. Hootc new foot around the presser bar and
tighten presser foot screw.
CHANGING PLATES
(Note: Remove bobbin if it contains thread in
order to prevent thread being caught when
plate is replaced.)
1. Raise take-up lever to its highest position
by turning the hand wheel toward you.
2. Raise presser foot.
3. Open slide plate. Press down on front edge
of plate and lift up and out.
4. Position new plate over pins and release.
Plate is drawn into position by magnets.
5. Close slide plate.
maszynykrawieckie.shophurt.pl