ADC Campus-REX2 RS User Manual page 80

Chapter 4 - Managing System Parameters
4
2 Type
this HDSL circuit, up to 64 characters.
Maximum length is 64 characters.
ENTER NEW CIRCUIT ID: Southeast line 421
The unit and circuit IDs are displayed as shown below. To configure or
change the unit and circuit IDs for the Campus unit at the other end of the
HDSL connection, access it using either telnet or the remote log on (see
"Logging In" on page
Jul 07, 2003
Local Unit ID: Southall Quad 4
Remote Unit ID: Central
Circuit ID: Southeast line 421
1) CHANGE SYSTEM TIME
2) CHANGE SYSTEM DATE
3) CHANGE UNIT ID
4) CHANGE CIRCUIT ID
5) CHANGE UNIT PASSWORD
6) HDSL ES Alarm Threshold:
7) HDSL Margin Alarm Threshold:
8) Local Data Port LOS Alarm:
9) Remote Data Port LOS Alarm:
10) RESTORE FACTORY DEFAULTS
ENTER CHOICE>
The new Unit and Circuit IDs take effect immediately after the values are
entered and a save command is not required.
68
ENTER
then press
12).
ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
SYSTEM PARAMETERS
. At the prompt, enter a unique identifier for
Local I/F:
Remote I/F: REX2
Disabled (Disabled, 17, 170)
Disabled
Disabled (Disabled, Enabled)
Disabled (Disabled, Enabled)
(R)eturn
Campus-REX2 RS Interface Card User Manual
REX2