Chapter 3 - Configuring the REX2
2
Manage the Static Route Table, including adding or deleting table
entries, by entering any of the following:
•
P
to access the previous screen of the table entries
•
N
to access the next screen of the table entries
•
F
to find a specific table entry; the user is prompted to specify an
IP address for the destination device:
•
E
to display all entries in a table without pages; this provides you
the capability to capture this information to a file using a terminal
emulation software such as HyperTerminal or ProComm
•
C
to clear all entries from the table
•
A
to add static route table entries (also see
Deleting Static IP Routes" on page
is displayed:
The following message is displayed:
•
D
to delete a static route table entry (also see
Deleting Static IP Routes" on page
is displayed:
3
Type
R
(page
3-46). (Typing
4
If you added or deleted static route entries, go to
Configuration" on page 55
58
Required format is nnn.nnn.nnn.nnn
Enter Destination IP Address: 172.100.200.60
Required format is nnn.nnn.nnn.nnn
Enter Destination IP Address: 192.128.128.60
Enter Destination IP Subnet Mask: 255.255.255.0
Enter Gateway IP Address: 192.150.10.50
Enter Hop Count: 3
Route added
Hit Any Key to Continue
Required format is nnn.nnn.nnn.nnn
Enter Destination IP Address: 192.128.128.60
then press
ENTER
M
will return you to the Main Menu.)
51) and the following prompt
51) and the following prompt
to return to the Router Configuration screen
to save your changes.
Campus-REX2 RS Interface Card User Manual
"Configuring and
"Configuring and
"Saving the Router