Table of Contents
Advertisement
Chapter 2 - Configuring HDSL Parameters
It is recommended that you leave the Transceiver Mode
option set to Auto unless you require that particular ends of
the HDSL connection be the Master and Slave.
Also, this value cannot be changed if the HDSL link is up.
2
To change the Transceiver Mode, type
Transceiver Mode changes to the next setting. Repeat until the preferred
setting is selected:
•
Master initiates the HDSL link. The other Campus unit must be set
to Slave or Auto.
•
Slave waits for the other Campus unit to initiate the HDSL link. The
other unit must be set to Master or Auto.
•
Auto (default) automatically switches between Master and Slave
until an HDSL link is established.
The Transceiver Mode option determines the hierarchy of the two
Campus units when attempting to establish an HDSL link.
3
To change the HDSL Loop Mode from 1 Loop (default) to 2 Loop, type
3
then press
4
To select an HDSL Rate, type
Rate screen that is displayed is dependent on whether you selected
1 Loop or 2 Loop for the HDSL Loop Mode. The minimum and
maximum rates are:
•
for 1 Loop, 128 kbps is the minimum and 2304 Mbps is the
maximum selected in 64 kbps increments; the default is 128 kbps
•
for 2 Loop, 256 kbps is the minimum and 4608 Mbps is the
maximum selected in 128 kbps increments; the default is 256 kbps
24
ENTER
.
4
2
then press
then press
ENTER
Campus-REX2 RS Interface Card User Manual
ENTER
. The
. The Select HDSL
Hide quick links:
Advertisement
Table of Contents
