Reporting Codes; Swinger Shutdown; Hardware Default; Communicator Reset/Update - DSC 3G4010CF Installation Manual

NOTE: Once an output has been activated automatically, it will not restore its state until all the causes of activation are cleared.

Reporting Codes

3G4010CF Reporting Codes
Zone 1 Activation
Zone 1 Restoral
Zone 2 Activation
Zone 2 Restoral
Zone 3 Activation
Zone 3 Restoral
Zone 4 Activation
Zone 4 Restoral
PSTN Line Down
PSTN Line Restoral
Periodic Test
Periodic Test with Trouble
Radio Activation
Internal Buffer Full
FTC Restoral
Firmware Update Successful R901 000 LS 000
Firmware Update Fail
Firmware Update Begin
System Tamper
System Tamper Restore
* C24 Communications default value
NOTE: The 3G4010CF does not support remote programming (local hardware default required). Upon activation through Con-
nect 24, the product will operate as described in this manual.

Swinger Shutdown

To prevent "runaway" signals to the central station, the 3G4010CF is equipped with Swinger Shutdown which limits certain
trouble events to a maximum of four reports every 24 hours. The condition will restore and the counter will reset at midnight.
Swinger Shutdown applies to the following trouble conditions:
System Tamper/Restore
l
Low Battery Trouble/Restore
l
TLM Trouble/Restore
l
Input Power Trouble/Restore
l
FTC Restore
l

Hardware Default

A local hardware default is required in order to update the unit with the latest configuration from C24 Communications.
To perform the hardware default, follow these steps:
1. Power down the unit (remove primary DC power and remove the backup battery) and remove all connections to Zone1,
Zone 2, PGM1 and PGM.
2. Connect a wire between Z2 (terminal 7) and PGM2 (terminal 8) or Z1 (terminal 13) and PGM1 (terminal 7).
3. Power up the radio by connecting the battery first and then primary DC power.
4. Wait for 20 seconds and then completely power down the unit.
5. Disconnect the wire between the Zone and PGM terminals.
6. Power up and let the unit complete the update (the LEDs will stop flashing when the downloading is complete).
NOTE: Failure to perform hardware default will result in the unit transmitting with the previously programmed configuration.

Communicator Reset/Update

The firmware of the device can be updated over Cellular or PC-Link:
When the firmware update begins, all LED are ON.
l
CID SIA Programmable
E301 991 AT 991
R301 991 AR 991
E200 992 FS 992
R200 992 FV 992
E110 993 FA 993
R110 993 FH 993
E300 994 YX 994
R300 994 YZ 994
E351 000 LT 000 FIXED
R351 000 LR 000 FIXED
E603 XXX RP XXX FIXED
E608 XXX RY XXX FIXED
R552 000 RS 000 FIXED
E624 000 JL 000 FIXED
R354 000 YK 000 FIXED
FIXED
E902 000 LU 000 FIXED
E901 000 LB 000 FIXED
E145 000 ES 000 FIXED
R145 000 EJ 000 FIXED
12
Comments
YES AC Loss*
YES AC Loss Restore *
YES Fire Supervisory*
YES Fire Supervisory Restore*
YES Fire *
YES Fire Restore *
YES System Trouble *
YES System Trouble Restore *
Telco 1 Fault
Telco 1 Fault Restore
Test Transmission <Receiver Path>
Test Transmission <Receiver Path>
Remote Programming Successful
Communications Restored
Expansion Module Tamper
Expansion Module Tamper Restore