Temp Intermittant: Why Does My Temp/Humidity Reading Come And Go; Humidity Shows Dashes But Temperature Works; Why Am I Going Through Batteries Quickly; How Do I Change Between Fahrenheit And Celsius - La Crosse Technology 330-2315 Manual

TEMP INTERMITTANT: WHY DOES MY TEMP/HUMIDITY READING COME AND
• RF (radio frequency) communication may come and go occasionally. This can be
normal in some environments (e.g. moister climates).
• If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be
patience – these stations can reconnect on, after many hours out.
• RF (radio frequency) communication is not always 100% on. Certain temporary
conditions can cause it to go out for a time (e.g. 100% humidity).
If a miss happens:
• If sensor loses connection to the weather station for any reason, the weather station
will show dashes after 30 minutes.
• The weather station will search for 5 minutes every hour to reconnect with sensor.
• Be sure you have good batteries. Manually search for your sensor.
Try this:
• Bring your sensor within 10 feet of your station and make sure it is connected to the
station.
• After 15 minutes move the sensor into the next room with a wall between the sensor
and the station for 1 hour.
• If there is no loss of signal in that hour, move the sensor just outside.
• Continue moving the sensor back to its original location.
• If you lose connection, look for sources of

HUMIDITY SHOWS DASHES BUT TEMPERATURE WORKS

• The humidity low range is 10% RH. If your local humidity is below 10% you will see this
reading.
• If temperature is working the sensor is working
• Press and release the SENSOR button to view sensor ID. Compare with ID sticker in
the battery compartment of the sensor.

WHY AM I GOING THROUGH BATTERIES QUICKLY?

• Test a new set of
batteries.
• When the batteries fail, please note the date and voltage again. This is helpful in
determining the problem.
• Check for leaking batteries, which may damage the sensor.

HOW DO I CHANGE BETWEEN FAHRENHEIT AND CELSIUS?

• On your sensor, open the battery cover and press the F/C button. This will change the
temperature display on the sensor only.
• On your station enter the
display on the station.
La Crosse Technology, Ltd.
batteries. Write down the date of installation and the voltage of the
program menu
GO?
interference.
to select Fahrenheit or Celsius temperature
Page 9