Backlight: Does This Station Have A Backlight; Why Are My Forecast Icons Inaccurate - La Crosse Technology 330-2315 Manual

24. WIND MPH (miles per hour) will show. Press the + / - buttons if you prefer KMH (kilometers
per hour).
25. Press the SET button to confirm adjustments and move to select rain in Inches or Millimeters.
26. RAIN IN (inches) will show. Press the + / - buttons to change to "MM" millimeters).
27. Press and release the SET button to confirm and exit.
28. Note: Press the LIGHT button at any time to exit.

BACKLIGHT: DOES THIS STATION HAVE A BACKLIGHT?

A/C adapter: The backlight is on continuously when operating the station with the 5-volt
a/c adapter.
Note: When the Adapter is NOT in use, the Hi/Low/Off light feature is not available.
Try this exercise in a dim room. The station has a bright, dim and OFF setting for the
backlight. Wait 15 seconds after pressing the LIGHT button to see if backlight stays on.
This will assure it is not in OFF mode.
1. Be sure the AC cord is correctly inserted to the station and the outlet.
2. Remove the batteries.
3. Press the LIGHT button. If the backlight comes on and the display is active
your AC cord works.
4. Wait 15 seconds to see if the back light stays on.
5. If the backlight goes out after 15 seconds, repeat #3.

WHY ARE MY FORECAST ICONS INACCURATE?

Your station predicts weather condition of the next 12-hours based on the change of
atmospheric pressure with 70-75% accuracy.
Note: As weather conditions cannot be 100% correctly forecasted we are not responsible
for any loss caused by an incorrect forecast.
Forecast Icons:
 Sunny
 Partly Sunny
 Cloudy
 Rain
 T-Storm
 Snow
Note: The "snow" icon appears when the temperature is below 32°F (0°C) and the forecast
is rainy or stormy.
 Your station calibrates barometric pressure based on its location over time to generate
an accurate, personal forecast. Please allow 7-10 days for barometer calibration.
 The forecast station samples the barometric pressure every twelve minutes. These
samples are averaged hourly and daily then stored in nonvolatile memory. The three
hour pressure icon change is based off of the last four average hourly readings.
 IMPORTANT: As your station builds memory, it will compare the current average
pressure to the past forty day average pressure for increased accuracy. The longer
your station operates in one location the more accurate the forecast icons will be.
La Crosse Technology, Ltd. Page 16