Table of Contents
Advertisement
•
If this is a common occurrence you can purchase an LTV-TH2 sensor and replace the
Temperature/Humidity Reading from the Wind/TH sensor.
HOW TO REPLACE THE TH READING FROM THE WIND TH SENSOR WITH
The new Wind Speed, Wind Direction Sensor with Temperature/Humidity may cause inaccurate
temperature readings in some locations. Because of this, you have the option to remove the TH
sensor reading (from the LTV-WSDTH03 OR LTV-WSDTH04) and adding an additional TH
sensor to read in the OUTDOOR area of the display.
1. Press SENSOR button once Station ID will show.
2. Press SENSOR button again ID WTH123 THW SENSOR will show.
3. Hold the MINUS (-) button for 5 seconds while viewing ID to delete ID WTH123.
To add a separate LTV-TH2 sensor:
• After deleting the TH sensor built into the Wind Sensor (ID: WTH123), press the SENSOR
button on the station to view ID, then press the TEMP button to search.
• Press the TX button on the add-on sensor.
• Sensor Icon
WHAT DOES A READING OF "HI" OR "LO" MEAN?
•
If your outdoor temperature reading shows "HI" or "LO", check that your
•
Overpowered or underpowered batteries can cause this reading.
•
If batteries are good, replace the outdoor sensor.
•
If your temperature is fine but your humidity is reading "HI" or "LO" or dashes, your humidity
may be below 10% Relative Humidity. Your sensor does not read below 10% humidity.
TEMP INTERMITTANT: WHY DOES MY TEMP/HUMIDITY READING COME
•
RF (radio frequency) communication may come and go occasionally. This can be normal in
some environments (e.g. moister climates).
•
If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be patient
– these stations can reconnect on, after many hours out.
•
RF (radio frequency) communication is not always 100% on. Certain temporary conditions
can cause it to go out for a time (e.g. 100% humidity).
If a miss happens:
•
If sensor loses connection to the station for any reason, the station will show dashes after 30
minutes.
•
The station will search for 5 minutes every hour to reconnect with sensor.
A LTV-TH2?
will show to indicate reading is coming from separate TH sensor.
AND GO?
batteries
are good.
17 |
P a g e
Advertisement
Table of Contents
