Table of Contents
Advertisement
•
Press and release the SENSOR button to view the thermos-hygro sensor ID number. Compare the barcode on
your sensor to be sure they match.
•
If your temperature is reading low, and location is not an issue, you may have a bad sensor.
•
If your outdoor temperature reading shows "HI" or "LO," check that your
•
Overpowered or underpowered batteries can cause this reading.
•
If the batteries are good, replace the outdoor sensor.
•
If your temperature is fine but your humidity is reading "HI" or "LO" or dashes, your humidity may be below
10% Relative Humidity. Your sensor does not read below 10% humidity.
TEMP INTERMITTANT: WHY DOES MY TEMP/HUMIDITY READING COME AND GO?
•
RF (radio frequency) communication may come and go occasionally. This can be normal in some environments
(e.g., moist climates).
•
If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be patient – these stations
can reconnect on, after many hours out.
•
RF (radio frequency) communication is not always 100% on. Certain temporary conditions can cause it to go
out for a time (e.g., 100% humidity).
If a miss happens:
•
If the sensor loses connection to the station for any reason, the station will show dashes after 30 minutes.
•
The station will search for 5 minutes every hour to reconnect with sensor.
•
Be sure you have good batteries. Manually search for your sensor by holding the SENSOR button for three
seconds.
Try this:
•
Bring your sensor within 10 feet of your station and make sure it is connected to the station.
•
After 15 minutes move the sensor into the next room with a wall between the sensor and the station for 1 hour.
•
If there is no loss of signal in that hour, move the sensor just outside.
•
Continue moving the sensor back to its original location.
•
If you lose connection, look for sources of
•
Test a new set of
batteries.
•
When the batteries fail, please note the date and voltage again. This is helpful in determining the problem.
•
Check for leaking batteries, which may damage the sensor.
HOW DO I CHANGE BETWEEN FAHRENHEIT AND CELSIUS?
•
On your sensor, open the battery cover and press the F/C button. This will change the temperature display on
the sensor only.
•
On your station enter the
•
Check for debris or ice preventing cups from moving.
WHAT DOES A READING OF "HI" OR "LO" MEAN?
interference.
WHY AM I GOING THROUGH BATTERIES QUICKLY?
Write down the date of installation and the voltage of the batteries.
program menu
to select Fahrenheit or Celsius temperature display on the station.
WHY ARE MY WIND CUPS NOT SPINNING?
batteries
are good.
14 |
P a g e
Advertisement
Table of Contents
