Battery Replacement Procedure
For safe operation and maintenance of the product:
•
Batteries contain hazardous chemicals that can cause burns
or explode. If exposure to chemicals occurs, clean with
water and get medical aid.
•
Remove all probes, test leads, and accessories before the
battery door is opened.
•
Remove all probes, test leads, and accessories before the
case is opened.
•
The battery door must be closed and locked before you
operate the product.
•
Use only specified replacement fuses and batteries.
•
Do not disassemble the battery.
To prevent possible damage to the product or to equipment
under test:
•
Do not attempt to repair or service the product unless
qualified to do so and you have the relevant calibration,
performance test, and service information.
•
Remove batteries to prevent battery leakage and damage to
the product if it is not used for an extended period.
•
Be sure that the battery polarity is correct to prevent battery
leakage.
•
Repair the product before use if the battery leaks.
•
Do not disassemble the battery.
•
Do not short the battery terminals together.
•
Keep cells and battery packs clean and dry. Clean dirty
connectors with a dry, clean cloth.
•
Do not disassemble or crush battery cells and battery
packs.
•
Do not keep cells or batteries in a container where the
terminals can be shorted.
•
Do not put battery cells and battery packs near heat or fire.
Do not put in sunlight.
This Product uses a rechargeable 12 V lead-acid battery for power. Storing
rechargeable lead-acid batteries in a low-charged state could decrease their life
and cause damage. Fully charge the battery before storing it for extended
periods and examine the charge at regular intervals.
Charge the 12 V lead-acid battery with the ac power cord. Expect up to 12 hours
to fully charge the battery. Do not charge in very high or low temperatures.
XW Warning
W Caution
Insulation Tester
Battery Replacement Procedure
17