Tripp Lite AG-879F Series Owner's Manual page 7

Feature Identification
C
ON/OFF Switch: When you set the switch to the ON position,
the Inverter provides AC power by converting DC power from the
connected 12V battery system. Set the switch to the OFF position
to shut down the Inverter and conserve the battery's charge when
you are not using connected equipment. Also set the switch to
the OFF position to reset the Inverter if it has shut down due to
overload or other critical events. See the Operation section for
more information.
D
LED Status Indicators: When the switch is set to the ON
position, the LED system will illuminate green during normal, low-
voltage alarm and output short circuit conditions. If there is an
overload, over-temperature, or if a high/low DC voltage shutdown
condition occurs, the LED system will illuminate red.
E
Temperature/Load-Controlled Cooling Fan: This fan regulates
the internal temperature of the inverter and prolongs service
life. It will only come on if the temperature or load demand goes
beyond the set thresholds.
F
DC Power Terminals: These positive and negative terminals
connect to the battery via the included or user-supplied cabling.
See Battery Connection for instructions.
18-11-134-9338A0.indb 7
LED Normal Low
Operation Voltage Voltage
Status (12V) Alarm
Green LED
ON ON
Status
Red LED
OFF OFF
Status
Alarm OFF ON
Low High
Voltage Voltage
Shutdown Shutdown Temperature
OFF OFF
ON ON
ON ON
7
Output
Over- Output Short
Overload Circuit
OFF OFF ON
ON ON OFF
OFF OFF OFF
12/5/2018 9:13:35 AM