2.2.8
Wall Mounting (KX-TDA15)
Mounting on Wooden Wall
1.
Place the reference for wall mounting (on the last page of this manual) on the wall to mark
the 3 screw positions.
2.
Install the screws and washers (included) in the wall.
Washer
Drive the screw
to this position.
Notes
•
Make sure that the screw heads are at the same distance from the wall.
•
Install the screws perpendicular to the wall.
3.
Hook the main unit on the screw heads.
Notes
•
Do not block the openings of the cabinet. Allow space of at least 20 cm above and 10
cm at the sides of the cabinet.
•
Make sure that the wall behind the cabinet is flat and free of obstacles, so that the
openings on the back of the cabinet will not be blocked.
•
Be careful not to drop the cabinet.
130 mm
250 mm
2.2 Installation of the Hybrid IP-PBX
Installation Manual
45