Toshiba 100CS Manual page 135

Gently disengage the FL holder and lift it out.
8.
Lift the end of the reflector sheet covering the FL tube and lift the FL tube out.
9.
Be careful not to pull or apply tension to the reflector sheet.
Installing the DSTN FL
To install the FL unit, follow the steps below and refer to figures 4-29 to 4-32.
Seat the FL tube, gently press it securely in place and cover it with the end of the
1.
reflector sheet. Be careful not to pull or apply tension to the reflector sheet .
Seat the FL holder and thread the FL tube cable into place.
2.
Secure the FL holder with two M2x3.4 screws .
3.
Seat the LCD module in its frame and secure it with four screws .
4.
Secure the 11 latches of the frame.
5.
6. Install the LCD module, FL inverter board, display mask, top cover, and the
battery pack as described in sections 4.15, 4.14, 4.13, 4.4, 4.3, and 4.2.
4-36
Figure 4-32 Removing the FL tube
100CS