Table of Contents
Advertisement
Unpacking
REMOVING THE KID
FROM THE SHIPPING BOX
One person can remove the KID from its shipping
box safely and easily.
1. Open the shipping carton top flap. You see the
literature pack containing:
1
Owner's Reference
1
Warranty Registration Card
2. Remove the literature pack and the top layer of
foam to view:
1
KID
1
AC power cord
1
KID remote control
1
CR2025 lithium battery
3. Face the front of the shipping box and remove
the foam insert containing the AC power cord
by pulling the insert straight out of the box.
4. Set the remote and the AC power cord aside,
for later use.
5. Insert your hands below the left and right
foam inserts surrounding the KID.
PLACEMENT CONSIDERATIONS
Before installing the KID into your system, please
review the following guidelines to choose the
proper location for the KID. This will facilitate a
clean, trouble-free installation.
Place the KID on a firm, level surface, away from
excessive heat, humidity, or moisture. The KID
does not require any type of special rack or cabi-
net for installation.
The measurements of the KID are:
13 W X 2.8 H X 10.9 D in
33 W X 7 H X 27.7 D cm
The KID requires the following clearance for ade-
quate ventilation:
— at least eight inches (20 cm) above (to
accommodate the iPod-device)
Krell
4
Krell
Placement
6. Lift the KID with the foam inserts straight out of
the box.
7. Place the KID on a safe place work surface, on
its side, resting on one of the foam inserts.
8. Remove the other foam insert.
9. Reposition the KID on the work surface, with the
side containing the remaining foam insert tilted
up.
10. Remove the second foam insert.
11. Remove the foam enclosing the compo-
nent.
If any of the listed items are not included in the
shipping box, please contact your authorized Krell
dealer or distributor.
Save all packing materials. If you need to ship the
KID in the future, repack the unit in its original
packaging to prevent shipping damage. See
Return Authorization Procedure, on page 12, for
more information.
The ventilation grids, on the bottom of the KID
chassis, must be unobstructed.
If the KID is placed in a closed cabinet, more than
eight inches (20 cm) of clearance may need to be
provided above and below the component, or
small fans may be needed to increase ventilation.
The air space between the chassis and shelf must
be unobstructed.
AC Power Guidelines. Use only the power cord
provided with the KID. The use of the KID with
devices designed to alter or stabilize the AC
power may impair the ability of the interface dock
to perform optimally.
Advertisement
Table of Contents
