Chapter 2
Installing WLSE 1130-19 Hardware
General Precautions
Maintaining Safety with Electricity
78-16778-01
Observe the following general precautions when using and working with your
system:
Keep your system components away from radiators and heat sources, and do
•
not block cooling vents.
Do not spill food or liquids on your system components, and never operate
•
the product in a wet environment. If the computer gets wet, see the
appropriate chapter in your troubleshooting guide or contact the Cisco
Technical Assistance Center. For instructions on contacting the Technical
Assistance Center, see the section
in the Preface.
Do not push any objects into the openings of your system components. Doing
•
so can cause fire or electric shock by shorting out interior components.
Position system cables and power cables carefully; route system cables and
•
the power cable and plug so that they cannot be stepped on or tripped over.
Be sure that nothing rests on your system components' cables or power cable.
Do not modify power cables or plugs. Consult a licensed electrician or your
•
power company for site modifications. Always follow your local/national
wiring rules.
To help avoid possible damage to the system board, wait 5 seconds after
•
turning off the system before removing a component from the system board
or disconnecting a peripheral device from the computer.
Follow these guidelines when working on equipment powered by electricity:
If any of the following conditions occur contact the Cisco Technical
•
Assistance Center:
The power cable or plug is damaged.
–
An object has fallen into the product.
–
The product has been exposed to water.
–
The product has been dropped or damaged.
–
The product does not operate correctly when you follow the operating
–
instructions.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
Preparing to Install WLSE 1130-19 Hardware
Obtaining Technical Assistance, page xxv
2-5