Setting The Dip Switch - Planar Dome C3i Quick Reference

2

Setting the DIP Switch

Slide switch 1 on DIP switch S2 into the ON position to enable VGA mode. Enable VGA on
only one (1) DX2 display controller when you install multiple boards. Disable VGA on all DX2
display controllers if you are using a separate VGA card.
DIP Switch S2 Enable VGA Disable VGA
1 ON
4
OFF
3
Installing the Display Controller
Turn your computer off. Leave the power cord
plugged into the grounded outlet.
To install the controller
1 Turn off all peripherals. Disconnect all cables from
the back of your computer.
2 Remove the computer cover.
3 Remove the blank bracket from the
available PCI slot.
4 Insert the display controller into the PCI slot,
align the connector pins, and press the
board down until it is firmly seated.
5 Secure the mounting bracket.
6 Reattach the computer cover and the peripherals.
When installing multiple DX2 display controllers,
install all boards before you install the driver.
Open 64-bit
Remove blank
PCI slot
bracket
DX2 display
controller installed
5