Set The Dip Switch - Planar C5i Reference Manual

QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Display
Package Contents
Identify Components
Position Display
Desk Stand Features
INSTALLING THE DISPLAY
Set DIP Switch
Install Display Controller
Connect Video and Power
Install Display Driver
Change Display Properties
Dome CXtra Software
APPENDIXES
Troubleshooting
Specifications
LED Status Lights
Single Desktop
USB Connection
Component Removal
Power Management
Palette Options

Set the DIP Switch

For either the DX or DX2 display controller, slide switch 1 on DIP switch S2 into the
ON position to enable VGA mode. Enable VGA on only one (1) board when you install
multiple boards, Disable VGA on all boards if you are using a separate VGA card.
For some Dell systems, you may need to enable VESA modes in order to see output
on the screen during the boot process. If so, slide switch 2 on DIP switch S2 into the
ON position.
Dome C5i Display
Lower right, DIP switch S2 on
the DX display controller
Upper left, DIP switch S2 on
the DX2 display controller
Switch settings
For single desktop mode, slide
switch 3 into the ON position.
The default landscape mode, set
by switch 4, is unavailable for the
Dome C5i display.
Warning
If you leave the computer turned
on, you could get an electric shock
and cause damage to the system
components.
Remove the display controller
slowly from its package and static-
shielding bag to prevent an
electrostatic discharge.
Static electricity can damage the
controller. When touching the board
or parts of the motherboard, take
these precautions:
•
Wear an antistatic wrist strap.
•
Discharge your body's static
electricity repeatedly by
touching the power supply
or the metal surface of the
computer chassis.
7