Advertisement
2.
Connection Setting
The RS232 connection must use the following settings:
Baud Rate
19200
The display's RS232 connector is wired in the straight through configuration, with the pinout as
follows:
● Pin 2: Tx out
● Pin 3: Rx in
● Pin 5: Ground
● Shell: Ground
● All other pins: No connect
Note: RS232 commands over LAN can be achieved by opening a TCP connection on Port 23 to the
display.
Note: RS232 and LAN functionality will not work in standby mode if Power Saving Config is set to
Standby Mode. Use another Power Saving Config selection if RS232 or LAN support is needed.
Consult the Planar PS Series 4K Displays User Manual for more information.
Note: When the Power Saving Config setting is set to Networked Standby, the display's LAN
connection will only recognize the Wake-on-LAN magic packet. Other serial commands are not
recognized in standby. If full LAN serial command support is required in standby, use the Wake on
All or Always On settings. Consult the Planar PS Series 4K Displays User Manual for more
information.
Planar PS Series 4K Displays RS232 User Manual
020-1389-00C
Data Bit
Parity Bit
8
None
HW (RTS/CTS) or
Stop Bit
SW (XON/XOFF)
1
None
RS232 Codes
Page | 6
Advertisement
