FireplaceXtrordinair CoolSmart TV Manual page 28

Fourth (final) Layer

Once the third layer is removed, a final cover plate will be visible. Use a ¼" nutdriver to loosen the screw securing
the plate. Reach in and rotate the cover plate to uncover the final hole.
NOTE: The final plate does not get removed from the fireplace, just rotated to uncover the hole. Once the plate has
been rotated, tighten the screw to lock the plate in place.
a

Install the starter collars onto the fireplace (see below).

Install the fireplace into the framed chase. See section "Installation" in the manual.
Page 28 of 33
CoolSmart TV
864, PB 42 Linear, PB 42 CF, 4415 HO
Sku# 98900779
1/4" Nutdriver
17602029- 9/24/19
b
Starter Collar
Use silicone to seal the
starter collar to the top
of the fireplace.
Bend the tabs on the
bottom of the starter
collar up to lock it in
place.
NOTE: When all the plates
have been removed, it should
look this the image below.
© Travis Industries, Inc.