Operating The System; Plug And Play; Demostration Mode - Philips FW-C100/25 User Manual

MINI HIFI SYSTEM
STANDBY-ON
CD1 • 2 • 3
DSC
Important:
Before you operate the system, complete
the preparation procedures.

Plug and Play

The system provides PLUG and PLAY feature
that allows you to store all available radio
stations automatically upon power up. If PLUG
and PLAY has been installed beforehand, it
will go to standby or demonstration mode
after 5 seconds.
1
Press and hold PLAY (on the system only) for 5
seconds; when the system is in standby or
demonstration mode.
If the PLUG and PLAY has not been installed
before, you can access this feature by switching
on the system from the main power outlet.
"AUTO INSTALL - PRESS PLAY" will be
displayed.
2
Press PLAY to start installation.
"INSTALL" will be displayed and followed by
"TUNER" and then "AUTO".
The starts flashing.
PROGRAM
PLUG and PLAY will start searching for all
radio stations on FM band and then followed by
radio stations on MW and LW bands
respectively.
All available radio stations with sufficient signal
strength will be stored. Up to 40 presets may be
stored.
The last preset radio station will appear on
the display when PLUG and PLAY is completed.
pg 01-27/C100/22-Eng
BAND TAPE 1 • 2
CD TUNER TAPE
DEMO STOP
TUNING PRESET
SEARCH STOP• CLEAR PLAY• PAUSE PREV NEXT
•
PROGRAM CLOCK TIMER DYNAMIC BASS BOOST
DIGITAL SOUND CONTROL
11

Operating the System

•
3 CD ROTARY CHANGER SYSTEM
•
CD REWRITABLE COMPATIBLE
•
CD SYNCHRO RECORDING
VIDEO MASTER
VOLUME
AUX
To exit without storing the PLUG and PLAY,
press Ç button (on the system only).
Notes:
– PLUG and PLAY will be reinitiated again during
the next power up if :
i) PLUG and PLAY installation was not
completed.
ii) No stereo frequency being detected during
PLUG and PLAY, "CHECK ANTENNA" will be
displayed.
– You can store any radio stations manually or
automatically after PLUG and PLAY.
– When PLUG and PLAY is used, all previously
stored radio stations will be replaced.
– During PLUG and PLAY, if no button is pressed
within 15 seconds, the system will go to
demonstration mode (if demonstration mode is
enable)
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the system.
To disable the demonstration mode
Press and hold Ç (on the system only) for 5
seconds when the system is in demonstration
mode.
"DEMO OFF" is displayed.
The system will switch to standby mode.
12/6/00, 3:18 PM
2
CD TAPE 1/2 TUNER
DIM AUX SLEEP
CD DIRECT
1 2 3
REPEAT PAUSE SHUFFLE
Å
VOLUME
É
í ë
Ç
á
à
MUTE
DSC DBB
11
3139 115 20281