Advertisement
USER-MAINTENANCE
INSTRUCTIONS
CARE OF yOUR CLIPPERS
IF yOU DETERMINE THAT BLADE
ALIGNMENT IS INCORRECT:
Conair ® hair clippers are carefully inspected to
insure that the blades are in perfect alignment.
Of course you will need to realign the blades
after removal for cleaning or replacement, or if
they should be knocked out of alignment. How
can you tell if blades need realigning? Simply
match them up, point for point, to conform with
FIG. 1 below:
To prevent the clipper from contacting the skin
or cutting too closely, make certain that the
end top blade teeth are 1/32" to
1/16" back from bottom blade.
To Align Blades:
1. Add two or three drops
of Conair Lubricating Oil
(included).
2.Turn clipper on for a minute
to disperse oil evenly over
blades, then turn off.
FIG. 1
FIG. 2
3. Unplug clipper and slightly loosen screws.
(See FIG. 2)
4. Position the extreme left-hand tooth of
the top blade so that it either covers or
appears on the left of the first small tooth
on the bottom blade.
5. Make sure that the big tooth on the
bottom blade touches the extreme right
hand tooth of the top blade.
SPECIAL OIL
To maintain the blades of your Conair ®
clipper, oil them after every three or four hair-
cuts. Gently place a few drops of oil on the
teeth of the blades, using the special Conair oil
included with your set. Turn the clipper on for a
minute, then turn off. This light, natural oil was
formulated specifically for the Conair ® high-
speed clipper. Be cause it is the right oil to use,
it will not slow down the blades. Never use any
other product. There is no substitute for Conair
oil. Keep oil away from children.
Advertisement
